Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!oberon!pollux.usc.edu!papa
From: papa@pollux.usc.edu (Marco Papa)
Newsgroups: comp.sys.amiga.tech
Subject: Re: Serial Line Control Register
Keywords: Where is it?
Message-ID: <16196@oberon.USC.EDU>
Date: 31 Mar 89 17:48:24 GMT
References: <2160@viscous.sco.COM>
Sender: news@oberon.USC.EDU
Reply-To: papa@pollux.usc.edu (Marco Papa)
Organization: Felsina Software, Los Angeles, CA
Lines: 17

In article <2160@viscous.sco.COM> brianm@sco.COM (Brian Moffet) writes:
>On the AT type machines, there are a couple of ports
>which are used to set or read the line control status.
>These are used to set RTS and DTR, or to read DTS, CTS, etc...
>I cannot find these ports (or their equivalant) in the old
>Hardware manual.  Is this info available in the new ones?
>I haven't got mine yet...
>I just want to know where to look at the hardware level to see
>if CTS or CD is set...

All the information is in the Appendix of the "old" Hardware Manual.

-- Marco Papa 'Doc'
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
uucp:...!pollux!papa       BIX:papa       ARPAnet:pollux!papa@oberon.usc.edu
 "There's Alpha, Beta, Gamma and Diga!" -- Leo Schwab [quoting Rick Unland]
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=