Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cornell!uw-beaver!blake!oregon!goes
From: goes@oregon.uoregon.edu (Jim Goes, Univ of Oregon)
Newsgroups: comp.sys.ibm.pc
Subject: Re: telix and com3
Message-ID: <411@oregon.uoregon.edu>
Date: 27 Mar 89 14:21:19 GMT
References: <94545@sun.Eng.Sun.COM> <341@oregon.uoregon.edu>
Distribution: usa
Organization: University of Oregon
Lines: 17

In article <341@oregon.uoregon.edu>, I wrote:
> In article <94545@sun.Eng.Sun.COM>, kirk%enterprise@Sun.COM ('Captain' Kirk DeHaan) writes:
>> 2.  Can Telix (3.11) be made to work with com3?  The docs say yes but
>> trying to do so results in a hung system.  Looking at the telix.cnf file
> -- 
> I've had the same problem with Telix.  I can get Procomm Plus to recognize the
> COM3 port but not Telix, even though I use the same IRQ and interrupt settings
-- 
Just a quick note that Keith Peterson sent me a copy of RS232OFF.ARC which
solves this problem.  RS2320FF is available in com.binaries.ibm.pc or on
SIMTEL20 in PD1:<MSDOS.MODEM>.  Thanks again, Keith.
_______________________________________________________________________________ 
Jim Goes                      |  InterNet   GOES@OREGON.UOREGON.EDU 
Graduate School of Management |  UUCP:      {fav backbone}!uoregon!oregon!goes
University of Oregon          |  MaBell:    (503) 686-3309
________________________________________________________________________________
Grad School. Its not just a job, it's an indenture...