Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!purdue!decwrl!decvax!zinn!ubbs-nh!noel From: noel@ubbs-nh.MV.COM (Noel Del More) Newsgroups: comp.sys.ibm.pc Subject: Re: Zenith XT Turbo Users? Message-ID: <279@ubbs-nh.MV.COM> Date: 27 Mar 89 17:58:47 GMT References: <4075@druhi.ATT.COM> <327@oregon.uoregon.edu> Reply-To: noel@ubbs-nh.MV.COM (Noel Del More) Organization: uBBS-NH (New England Unix Archive) - Nashua, NH Lines: 48 In article <327@oregon.uoregon.edu> michelbi@oregon.uoregon.edu (Michel Biedermann) writes: >In article <4075@druhi.ATT.COM>, terrell@druhi.ATT.COM (Eric Terrell) writes: >> I'd welcome the opportunity to correspond with other owners >> of the Zenith XT Turbo (CGA, 20 Meg HD, 720k 3.5 disk). >> 1. Is this computer socketed for an 8087? >> >> 2. Can it take a 5.25 floppy drive? Must this drive be >> external? From whom is the drive available? All of the Zenith PC/XT compatible systems, ie. Z-150, Z-160, Z-151, Z-152, Z-158 ext. are socketed for the 8087. Be sure to get a co-processor rated for the speed at which the CPU runs. The 158 and up run at 4.7/8 Mhz., the earlier systems run at 4.7 unless they have been souped up. All of the "150" series systems can handle two half height floppies and one half height hard disk. You need to drop the hard disk into the bottom of the mounting bracket, holes are already their, be sure to use short screws (1/4") to secure the drive as you no longer have the plastic hanger in the way and to long of a screw may cause damage/problems to the HD. You may have to trim the bottom 1/4" off the drive "B" plastic drive hangers to get everything to fit. Use sharp scissors or dikes to cut it, it will act as a spacer only, but the screws will hold the drive ok. Zenith used only Mitsubishi, Panasonic, and way back when, Shugart drives. Shugart was bought by Panasonic so no diff their. So check to see what you have and go by the same type. You will also need a power splitter cable (y cable). Run the HD off a main power cable, split the other power cable with the y cable and run it to the floppies. Problems, NONE. Limitations, you don't get to see the HD idiot light. Noel (former ZDS'er) P.S. I've done this on hundreds of machines, if you have problems send email, but don't ask ridiculous questions. Open the box, look around, use your noggin, than ask me specifics. If you can't find a power splitter cable I can refer you to a source. -- Noel B. Del More | {decvax|harvard}!zinn!ubbs-nh!noel 17 Meredith Drive | noel@ubbs-nh.mv.com Nashua, New Hampshire 03063 | It's unix me son! `taint spozed tah make cents