Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!agate!eos!riacs!davy
From: davy@riacs.edu (Dave Curry)
Newsgroups: ca.unix,comp.sys.sequent
Subject: Re: SLIP (Serial Line Internet Protocol) running on a Sequent or 4.2BSD bas
Keywords: SLIP
Message-ID: <1374@hydra.riacs.edu>
Date: 27 Mar 89 17:21:21 GMT
References: <38990@peregrine.peregrine.com>
Reply-To: davy@hydra.riacs.edu.UUCP (Dave Curry)
Distribution: usa
Organization: Research Institute for Advanced Computer Science
Lines: 13

In article <38990@peregrine.peregrine.com> robert@peregrine.peregrine.com (Robert Young) writes:
>I am looking for a SLIP package to run on a Sequent machine ( DYNIX 3.0.12).

SLIP for Sequent Balance/Symmetry systems was done by Phil Klimbal when
he was here at RIACS.  It is available for anonymous ftp from the host
riacs.edu in "pub/slip/sl.tar.Z".  Be sure to set image mode on the
transfer.

As far as I know, Phil did the work needed to make it run on multiple
processors, instead of leaving it single threaded.

Dave Curry
Research Institute for Advanced Computer Science