Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!bu-cs!bucsb!jbw
From: jbw@bucsb.UUCP (jbw)
Newsgroups: comp.terminals
Subject: DEC VT220 User Defined Keys (DECUDK)
Summary: inews garbage
Message-ID: <2412@bucsb.UUCP>
Date: 22 Mar 89 04:13:04 GMT
Reply-To: jbw@bucsf.bu.edu (Joe Wells)
Followup-To: comp.terminals
Organization: Boston Univ Comp. Sci.
Lines: 24

Dear Terminal Gurus,

How do I set User Defined Keys on a VT220?  I've read the VT220
Programmer Pocket Guide, and it's not quite obvious.  Unfortunately, I
don't have access to a VT220 Programmer's Reference Manual.  The
format given is this:

DCS Pc ; Pl | ky1/st1;ky2/st2;...kyn/stn ST
              ^^^^^^^^^^^^^^^^^^^^^^^^^^

DCS can be done by ESC P
ST can be done by ESC \
Pc is 0, 1, or empty.
Pl is 0, 1, or empty.

The part emphasized is the part I don't understand.  What is the
format that goes in there?

Thanks a lot for any help you can give me!

--
Joe Wells
INTERNET: jbw%bucsf.bu.edu@bu-it.bu.edu    IP: [128.197.10.201]
UUCP: ...!harvard!bu-cs!bucsf!jbw