Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!lll-winken!uunet!ispi!jbayer
From: jbayer@ispi.UUCP (Jonathan Bayer)
Newsgroups: comp.unix.xenix
Subject: Re: Need help installing 2nd HD
Message-ID: <558@ispi.UUCP>
Date: 22 Mar 89 15:08:10 GMT
References: <16070@cup.portal.com>
Reply-To: jbayer@ispi.UUCP (Jonathan Bayer)
Distribution: na
Organization: Intelligent Software Products, Inc.
Lines: 31

In article <16070@cup.portal.com> Chip_N_Oliver@cup.portal.com writes:
>Situation:  I have stumbled upon an AT clone running Xenix V2.2.  The
	[deleted]
>to "enable" the second drive.  I then ran dparam and set /dev/hd10
>identical to /dev/hd00 (or was it /dev/rhd00 and /dev/rhd10).
>
>I thought I was home free when badtrk ran a successful non-destructive
>scan of the second disk.  However, when I try to mount or fsck the second
>hd, I get the following:
>
># mount /dev/hd10 /u
	^^^^^^^^^^^^^^^

if you are going to do it this way you will want to use /dev/hd1?  where
the ? is the partition number you want to mount.  hd10 refers to the
entire hard disk.


>
>  mount: mount failed
>  mount: structure needs cleaning
>



JB
-- 
Jonathan Bayer			      Beware: The light at the end of the
Intelligent Software Products, Inc.	      tunnel may be an oncoming dragon
19 Virginia Ave.				...uunet!ispi!jbayer
Rockville Centre, NY 11570  (516) 766-2867    jbayer@ispi.UUCP