Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ncar!ames!lll-winken!netsys!vector!telecom-gateway From: Sirald@cup.portal.com Newsgroups: comp.dcom.telecom Subject: [WANTED]: APPLE-2 software for DEAF-TTY connections. Message-ID: Date: 3 Apr 89 15:22:02 GMT Sender: news@vector.UUCP Lines: 30 Approved: telecom-request@vector.uucp X-Submissions-To: telecom@eecs.nwu.edu X-Administrivia-To: telecom-request@vector.uucp X-TELECOM-Digest: volume 9, issue 122, message 5 of 7 I'm looking for APPLE-2 software or a BASIC program that will connect me to a DEAF-TTY. DTTY uses the BAUDOT character set (5-bit data words). APPLE-2 uses the ASCII character set (8-bit data words). I need a interface be- tween the 45.5 baud rate that BAUDOT requires and the 300/ 1200 baud rate that I'm set-up with. I realize that the "APPLE-CAT" modem accomplishes this between h/w and s/w, but I'm trying to make due with what I have. If anyone out there can aim me towards the software for this (share/freeware?) or actually could port something simple over into BASIC or ASM/HEX, that would be most ap- preciated. If you don't happen to have even the foggiest of what I am speaking about, but could steer me towards other re- sources, THAT is also most appreciated. Please try to reach me at the following addresses; upon failure to reach me, please post back here. In advance, thank you for your time and effort. You may be the one to bring friends and family closer together - please give it a go. Cordially, A. DALRYMPLE sirald@cup.portal.com sun!portal!cup.portal.com!sirald