Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!leah!rpi!batcomputer!cornell!uw-beaver!uw-june!uw-entropy!quick!sumax!nwnexus!happym!rwing!rosebud!rkwood From: rkwood@rosebud.UUCP (Randy Wood) Newsgroups: comp.sys.amiga Subject: Hard Disk Problems... Message-ID: <1412.AA1412@rosebud> Date: 29 Mar 89 22:58:26 GMT Followup-To: comp.sys.amiga Lines: 33 HELP!!! I'm having some serious problems with my hard disk. The hardware consists of a C L'td SCSI controller (v. 2.x), an Adaptec 4000 SCSI->ST506 converter, and a Seagate ST-225 20 megabyte ST506 MFM hard drive. The software I'm currently running is WB 1.3 (FFS) and C L'td's SCSI_DOS v. 2.06. The problem is that the machine has great difficulty mounting DH0: the first time I turn the machine on. I have to Cntrl-A-A (warm boot) the machine about a dozen times before it will recognize DH0: as a dos disk. Otherwise it will pop up a little system requestor saying "Not a DOS Disk in DH0:.... Use DiskDoctor...". Once the machine recognizes DH0: I have no further problems and subsequent warm-boots are trouble free. This problem first appeared the day after I ran B.A.D., a hard disk optimizing program. At first, I only had to try warm booting the machine several times before my 1000 would recognize DH0: on the initial power-up. However the situation has become progressively worse... I've tried reformatting DH0: with both the C L'td low-level utilities and the AmigaDOS format command. Everything looked OK until I powered down and then powered back up.... I would hate to think I might have to junk my hard drive, which had worked perfectly for almost 2 years, in favor of a new Supra or C L'td drive. :^( Do the comp.sys.amiga net-gods have any ideas or suggestions??? -- +=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+ | Randy Wood RKW Technologies, 271 NE 45th St, Seattle, WA 98105 | | (206) 363-TECH UUCP: rkwood@rosebud.UUCP | +=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+