Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!husc6!ogccse!blake!mtsu
From: mtsu@blake.acs.washington.edu (Montana State)
Newsgroups: comp.sys.hp
Subject: Question on HP disc controllers.
Message-ID: <1564@blake.acs.washington.edu>
Date: 12 Apr 89 21:23:43 GMT
Reply-To: mtsu@blake.UUCP (Montana State)
Distribution: usa
Organization: University of Washington, Seattle
Lines: 19



I'm trying to put two hi-speed HPIB interfaces in an HP9000/350 SRX.

I'm going to be adding a couple of disc drives, and since one of the drives
is from a node that is now discless I wanted to pull it's 98625A interface
and put in the 350.  I changed the select code to 26, but when booting
under HPUX 6.0  It finds the new interface, but then panics because
it's not on a 'unique interrupt level'  So I change the Ilevel to 6 and
reboot.  Everything looks good, except that it says it's an
unsupported configuration when it boots.  So how do you really put 2
hi-speed HPIB's in a 350?

Replies to :

icsu6000@caesar.cs.montana.edu or icsu6000@mtsunix1.BITNET

Thanx a bunch.
Jaye Mathisen