Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!agate!jif!wainscot
From: wainscot@jif.berkeley.edu (Brian Wainscott)
Newsgroups: comp.sys.ibm.pc
Subject: Procomm at 2400 (was RE: Procomm and vt100)
Message-ID: <22828@agate.BERKELEY.EDU>
Date: 8 Apr 89 20:52:58 GMT
Sender: usenet@agate.BERKELEY.EDU
Lines: 29


Thanks to all of you who helped with my procomm problems.  Here's
the current status (please read on -- I still need help).

I can download fine at 2400 baud, and upload at 1200, but cannot
upload at 2400 baud, even in ascii!  After a seemingly good start
(3 lines ascii, sometimes as much as 2 blocks in xmodem) the system
locks and nothing short of ctl-alt-del gets any response.
Any comments or suggestions would be greatly appreciated.

My current setup is as follows:

AT clone (with which I have had NO problems) at 10Mhz
Anchor 2400i internal modem on com4 (100% Hayes compatible)
    (mouse on com1, which is why modem is where it is)
Procomm 2.4.2
files = buffers = 40
I'm trying to talk to a Unix system.

All ideas welcome.  Thanks for the help!

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 Brian Wainscott        Graduate Student       U.C. Berkeley
 wainscot@math.berkeley.edu
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 Brian Wainscott        Graduate Student       U.C. Berkeley
 wainscot@math.berkeley.edu
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~