Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!ucsd!rutgers!orstcs!statware!scf
From: scf@statware.UUCP (Steve Fullerton)
Newsgroups: comp.unix.xenix
Subject: Re: SCO Support Problem and Problem for SCO Support
Message-ID: <1970@statware.UUCP>
Date: 11 Apr 89 15:13:36 GMT
References: <208@berner.UUCP> <3274@udccvax1.acs.udel.EDU> <1176@sbee.sunysb.edu>
Reply-To: scf@statware.UUCP (Steve Fullerton)
Organization: Statware, Corvallis, Oregon
Lines: 16

In article <1176@sbee.sunysb.edu> mhlevy@sbee.sunysb.edu (Mark Levy) writes:
>I have level 2 softcare for my XENIX 386 complete, and about 3 months ago, I 
>had a problem in the link phase of compiling XLISP in the form of "invalid 
>object module"..., and to this day I never found out what the 
>error that causes that message is.  

I would also love to find out what causes the "invalid object module"
message.  I ran into this about 8 months ago and was never able to
figure out what was happening.  SCO Support said they had never seen
it before.

-- 
Steve Fullerton                        Statware, Inc.
scf%statware.uucp@cs.orst.edu          260 SW Madison Ave, Suite 109
orstcs!statware!scf                    Corvallis, OR  97333
                                       503/753-5382