Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!unmvax!polyslo!ddurbin
From: ddurbin@polyslo.CalPoly.EDU (Daniel A. Durbin)
Newsgroups: sci.electronics
Subject: PCB's using transparancies
Keywords: PCB, layout, laserprint
Message-ID: <10028@polyslo.CalPoly.EDU>
Date: 7 Apr 89 20:57:29 GMT
Distribution: usa
Organization: Cal Poly State Univ,CSC Dept,San Luis Obispo,CA 93407
Lines: 15

There was some discussion a while back concerning the transfer of the
toner from a laser printed transparency of a PCB layout to the actual
copper of the PCB to be etched.

A friend of mine has tried this but has had trouble getting a good
transfer efficency of the toner to the copper.  This subject was discussed
in follow-ups to an article on PCB production, but I missed all of it.

If someone has a transcript of those discussions or an efficient method
of transfer, please forward them to me.  Thanks in advance.

	Daniel Durbin___________________________________________________
	SysOp: Cygnus X-1 BBS		| CIS: 73447,1744
	(805) 541-8505 (data)		| GEnie: D.DURBIN
	EL major at PolySlo		| ddurbin@polyslo.CalPoly.EDU