Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!lll-winken!uunet!wa3wbu!john
From: john@wa3wbu.UUCP (John Gayman)
Newsgroups: comp.mail.elm
Subject: Problems with Sys V/AT
Message-ID: <410@wa3wbu.UUCP>
Date: 15 Apr 89 02:11:20 GMT
Organization: WA3WBU, Marysville,PA
Lines: 20


    I'm trying to install Elm 2.2 on a Microport system running V/AT 2.4.
This system had previously been running Elm 2.1. I run Configure and it
gets all the way down to where it creates config.sh and then it core
dumps. I tried checking config.sh by hand and then manually running
config.h.SH and it core dumps. I'm assuming its actually config.h.SH
thats getting executing and causing the core dump. 

    Can anyone suggest a workaround or perhaps have run into this
situation on a 286 ?  I just installed Elm 2.2 on my 386 running V/386
3.0e and it is working fine. I'm puzzled.   Thanks.


					John


-- 
John Gayman, WA3WBU              |           UUCP: uunet!wa3wbu!john
1869 Valley Rd.                  |           ARPA: john@wa3wbu.uu.net 
Marysville, PA 17053             |           Packet: WA3WBU @ AK3P