Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!agate!eos!ames!pacbell!pbhyf!rob
From: rob@PacBell.COM (Rob Bernardo)
Newsgroups: comp.mail.elm
Subject: Re: Problems with Sys V/AT
Message-ID: <5029@pbhyf.PacBell.COM>
Date: 15 Apr 89 15:03:47 GMT
References: <410@wa3wbu.UUCP>
Reply-To: rob@PacBell.COM (Rob Bernardo)
Organization: Pacific * Bell, San Ramon, CA
Lines: 15

In article <410@wa3wbu.UUCP> john@wa3wbu.UUCP (John Gayman) writes:
+
+    I'm trying to install Elm 2.2 on a Microport system running V/AT 2.4.
+This system had previously been running Elm 2.1. I run Configure and it
+gets all the way down to where it creates config.sh and then it core
+dumps. I tried checking config.sh by hand and then manually running
+config.h.SH and it core dumps. I'm assuming its actually config.h.SH
+thats getting executing and causing the core dump. 

The README file outlines this problem.
-- 
Rob Bernardo, Pacific Bell UNIX/C Reusable Code Library
Email:     ...![backbone]!pacbell!pbhyf!rob   OR  rob@pbhyf.PacBell.COM
Office:    (415) 823-2417  Room 4E850O San Ramon Valley Administrative Center
Residence: (415) 827-4301  R Bar JB, Concord, California