Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!ucsd!sdcsvax!ucsdhub!hp-sdd!ncr-sd!crash!pnet01!jdeitch
From: jdeitch@pnet01.cts.com (Jim Deitch)
Newsgroups: comp.os.minix
Subject: Minix on DTK 1010 mother board
Message-ID: <4098@crash.cts.com>
Date: 22 Apr 89 01:16:13 GMT
Sender: news@crash.cts.com
Organization: People-Net [pnet01], El Cajon CA
Lines: 19

I would like to add this configuration to the list:
 
 DTK 1010 (10 mhz. 0 waitstate) motherboard
 Maxtor XT 1140 Hard disk
 MG-200 monographics card
 WD 1003 WA2 Controller

The only problem I had was with the 16550 uart on my serial card.  I fixed the
problem, and gained some speed from the rs232 driver.  I am sending the diff
to Andy before issuing them.  In case you don't know, the 16550 is a drop in
replacement for the 16450 and 8250 uarts, but with an on board FIFO that
allows you to determine when the uart interupts the system.

 Jim


UUCP: {nosc ucsd hplabs!hp-sdd}!crash!pnet01!jdeitch
ARPA: crash!pnet01!jdeitch@nosc.mil
INET: jdeitch@pnet01.cts.com