Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uflorida!beach.cis.ufl.edu!dor
From: dor@beach.cis.ufl.edu (Douglas R. Oosting)
Newsgroups: comp.sys.ibm.pc
Subject: Serial port vs modem, divorce proceedings
Keywords: If at first you dont succeed...
Message-ID: <20164@uflorida.cis.ufl.EDU>
Date: 24 Apr 89 20:44:00 GMT
Sender: news@uflorida.cis.ufl.EDU
Reply-To: dor@beach.cis.ufl.edu (Douglas R. Oosting)
Followup-To: comp.sys.ibm.pc
Distribution: usa
Organization: UF CIS Department
Lines: 26


Thanks to all who tried to give advice (including Keith Peterson, maintainer
of the simtel20 archives) that I could not mail back to (retarded mailer)
BUT we still have this problem.

The modem works just fine with serial card 'A.'  With card 'B'
however, the modem doesnt want to acknowledge the reset command from
my program.  ProComm works just fine.  The port addressess are correct,
the IRQ line is set properly, there isnt a two-port conflict...its not
out-of-date software (asynchronous routines by Phil Burns, PibTerm 4.1)


Sigh...

Are there any other hints out there or am I stuck writing my own driver?
(Bwaaa hah ha!!)
Thanks in advance...


Douglas Oosting

--
Entropy Requires     | Douglas R. Oosting, University of Florida
No maintenance...    | dor@beach.cis.ufl.edu or Pendragon@oak.circa.ufl.edu 
   --Markoff Chaney  |...{mailrus|gatech}!uflorida!beach.cis.ufl.edu!dor
In the Society : Cadrys ap Dulas o Caereira, Barony of An Crosaire, Trimaris