Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ames!lll-winken!uunet!ncrlnk!ncr-sd!hp-sdd!hplabs!hpda!hpcuhb!hp-ses!hpcea!twakeman
From: twakeman@hpcea.CE.HP.COM (Teriann Wakeman)
Newsgroups: comp.sys.mac
Subject: 5V adjust info wanted
Message-ID: <430099@hpcea.CE.HP.COM>
Date: 20 Apr 89 17:06:16 GMT
Organization: HP Corporate Engineering - Palo Alto, CA
Lines: 9

I would like to check/adjust the 5V supply on my Mac+. There is a 
cable from the middle of the analogue board to the middle of the digital
board. The soldered ends of the pins are readilly accessable on the underside
of the digital board. I assume this cable carrys 5V to the digital board.
Can anyone tell me which pin carrys the 5V? Or if there is a better place to
measure the 5V?????Is the correct voltage 5.0?

TeriAnn
twakeman@hpcea.ce.hp.com