Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!iuvax!rutgers!apple!bbn!bbn.com!slackey
From: slackey@bbn.com (Stan Lackey)
Newsgroups: comp.lsi.cad
Subject: Re: SPICE probs
Message-ID: <39418@bbn.COM>
Date: 3 May 89 15:56:52 GMT
References: <17979@obiwan.mips.COM> <4240001@hpcilzb.HP.COM>
Sender: news@bbn.COM
Reply-To: slackey@BBN.COM (Stan Lackey)
Organization: Bolt Beranek and Newman Inc., Cambridge MA
Lines: 12

A while a go I wrote:
> >I am trying to make a model for a schottky diode.  I set the eg parameter

In article <4240001@hpcilzb.HP.COM> rd@hpcilzb.HP.COM (Dick Dowell) writes:
> EG is only used in the calculation of IS versus temperature.
> You can either put a larger value
> for IS, or a smaller value for N in to change this.

Thanks for your reply.
I ended up calling the HSPICE hotline and they suggested the lower value
for N, which is what I did and it is behaving as I would expect.
-Stan