Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!rutgers!apple!well!jax
From: jax@well.UUCP (Jack J. Woehr)
Newsgroups: comp.realtime
Subject: Re: Recommendations for remote debugger and monitor for 80x86
Summary: The Obvious Answer
Keywords: Forth
Message-ID: <11542@well.UUCP>
Date: 6 May 89 01:55:03 GMT
References: <8544@siemens.siemens.com>
Reply-To: jax@well.UUCP (Jack J. Woehr)
Distribution: usa
Organization: Whole Earth 'Lectronic Link, Sausalito, CA
Lines: 17

In article <8544@siemens.siemens.com> jrv@demon.siemens.com (James R Vallino) writes:
>I am looking to start work on an embedded system application.  Rather than
>use in circuit emulation I want to try remote debugging using a resident
>monitor in the target hardware.  I will be working with 80286 systems.

	The obvious answer: you want Forth, the embedded systems
programming language/op system/monitor with "live feedback". Check
out the Laboratory Microsystems and Harvard Softworks offerings of target
compilers and resident systems.

{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}
{}                                                                        {}
{} jax@well     ." Sysop, Realtime Control and Forth Board"      FIG      {}
{} jax@chariot  ." (303) 278-0364 3/12/2400 8-n-1 24 hrs."     Chapter    {}
{} JAX on GEnie       ." Tell them JAX sent you!"             Coordinator {}
{}                                                                        {}
{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}