Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ames!oliveb!sun!pepper!cmcmanis
From: cmcmanis%pepper@Sun.COM (Chuck McManis)
Newsgroups: comp.sys.amiga.tech
Subject: Re: Lattice 5.02 & CodeProbe 1.02
Keywords: Lattice 5, CodeProbe
Message-ID: <102760@sun.Eng.Sun.COM>
Date: 3 May 89 21:17:25 GMT
References: <1435@onion.reading.ac.uk>
Sender: news@sun.Eng.Sun.COM
Reply-To: cmcmanis@sun.UUCP (Chuck McManis)
Organization: Sun Microsystems, Mountain View
Lines: 17

In article <1435@onion.reading.ac.uk> sjf@reading.ac.uk (Steve Fisher) writes:
>  For example when trying to step through the lines.c demo
>I get as far as opening the window & then hello GURU.
>The GURU is usually 3 or 4 and the address corresponds to
>that given as the task address on the Dialogue window.

Codeprobe 1.02 must have the stack set for it. So on your CLI type 
STACK 25000 before running codeprobe. That should cure your problem.
This is a known problem (it was mentioned a couple of times in the BIX
lattice conference) they said it would be fixed in 5.0.3 or 5.1 whichever
came first.


--Chuck McManis
uucp: {anywhere}!sun!cmcmanis   BIX: cmcmanis  ARPAnet: cmcmanis@sun.com
These opinions are my own and no one elses, but you knew that didn't you.
"A most excellent barbarian ... Genghis Kahn!"