Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!unmvax!pprg.unm.edu!hc!ames!amdahl!pccuts!acs From: acs@pccuts.pcc.amdahl.com (Tony Sumrall) Newsgroups: comp.sys.amiga.tech Subject: Re: 16450? Message-ID: <790@pccuts.pcc.amdahl.com> Date: 9 May 89 08:01:22 GMT References: <696@solaria.csun.edu> Reply-To: acs@pccuts.pcc.amdahl.com (Tony Sumrall) Organization: Amdahl Corporation, Sunnyvale CA Lines: 26 In article limonce@pilot.njin.net (Tom Limoncelli) writes WRT 1.4 serial.device and its re-writing: ->P.S. Tony, can the new version of Vt100 include higher baud rates in ->the menus? Sure. Before I do it, though, I'll want someone with 1.4 to *test* it so that I don't supply something that will frustrate and confuse the novice. All of you possessors of 1.4, please step forward :-) Seriously, I *would* like to hear from anyone that has 1.4 and would be willing to try 2.9. It'll be a while before it's ready for beta-test but I'd still like to get some testers lined up. BTW, I am aware that the documentation is less than adequate for the novice and am taking steps to correct that in the next release. -> Tom Limoncelli -- tlimonce@drunivac.Bitnet -- limonce@pilot.njin.net -> Drew University -- Box 1060, Madison, NJ -- 201-408-5389 -> Standard Disclaimer: I am not the mouth-piece of Drew University -- Tony Sumrall acs@pccuts.pcc.amdahl.com <=> amdahl!pccuts!acs [ Opinions expressed herein are the author's and should not be construed to reflect the views of Amdahl Corp. ]