Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cornell!rochester!rutgers!att!alberta!uofaee!adec23!dragos!wally From: wally@dragos.UUCP (The Walrus) Newsgroups: comp.sys.atari.st Subject: Re: USING THE 1702 ON THE ST Summary: 1702? composite evile hacks Message-ID: <543@dragos.UUCP> Date: 6 May 89 12:09:31 GMT References: <890429.13121059.066380@SFA.CP6> Followup-To: comp.sys.atari.st Organization: Orbital Mind Control Lasers, Inc. Lines: 33 I don't know about cabling for all those other monitors, but I've been using a 1702 for my color display for about a year and a half. I'm mostly satisfied with it. It's true that it doesn't quite* have the resolution required for good medium res, but I can stil read the Icons and 80 col. text quite easily. In low res, the picture is quite acceptable, for games, and a paint program or two, or doing fractals . Cabling it up so it was convienient, however, was evil. Rather than mess around trying* to find that odd din plug, or shell out large stacks of cash for an overpriced switch box, what I ended up doing was making some mods to my SM125. First, I went and disassembled the monitor plug, and ran lines out the back of it for ground, audio and video, soldering onto the appropriate pins >. That was all well and good, and then I went inside the SM125 itself, and spliced a little on/off switch on the monochrome detect line. One li'l hole later, and a nice inconspicious, difficult to accidently trip switch now is poking out the side of my monitor. I leave both hooked up all the time, I've been very happey with the results. Total cost: $195 for the monitor, and $1.25 for the switch. When I get rich, I'll invest in a nice color Multisync, and dedicate the 1702 to running strictly with the VCR