Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!lll-winken!uunet!tektronix!tekgen!raven!mike
From: mike@raven.TELCOM.TEK.COM (Mike Ewan)
Newsgroups: comp.sys.ibm.pc
Subject: Re: GNUPLOT for PC
Message-ID: <1028@raven.TELCOM.TEK.COM>
Date: 9 May 89 22:41:50 GMT
References: <12759@ut-emx.UUCP> <1416@naucse.UUCP>
Reply-To: mike@raven.TELCOM.TEK.COM (Mike Ewan)
Organization: Tektronix, Beaverton OR
Lines: 20

In article <1416@naucse.UUCP> wew@naucse.UUCP (Bill Wilson) writes:
>I was able to rewrite the code so that it would compile very well
>with Turbo C.  The implementation supports Hercules, EGA/VGA, CGA
>and a few other graphics protocols.  If there is enough interest I will
>put the source on the net.
> 

Yes, please post it.







-- 
 Michael Ewan    (503)627-6468        ucbvax...\ 
 Tektronix Inc.                       decvax....\
 mike@raven.TELCOM.TEK.COM         uw-beaver.... >!tektronix!naps!raven!mike
 Fig Newton: The force required to accelerate a fig 39.37 inches/sec.