Xref: utzoo comp.sources.wanted:7338 comp.lang.postscript:2129
Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!cs.utexas.edu!uunet!mcvax!kth!sunic!liuida!andwi
From: andwi@majestix.ida.liu.se (Andreas Wickberg)
Newsgroups: comp.sources.wanted,comp.lang.postscript
Subject: Larger print area
Message-ID: <1263@majestix.ida.liu.se>
Date: 10 May 89 20:06:38 GMT
Organization: CIS Dept, Univ of Linkoping, Sweden
Lines: 7

The Apple print-manager gives the user an opportunity to increase the
printable area on the page. In Sweden the standard LaserWriter IINT
has about 1 cm margins that can be reduced to a few mm's with this
option on. I've tried to see in the Laser Prep how they do this, but
found it too stuffed away. The question: is there any 'clean' way of
doing this? Is the Apple function very device dependent (eg, will it
work on a VT600)? And what do they do?