Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uflorida!novavax!rwright
From: rwright@novavax.UUCP (Ronald K. Wright)
Newsgroups: comp.mail.uucp
Subject: Re: uucico
Keywords: uucico xenix 386ps g_protocol trailblazer
Message-ID: <1270@novavax.UUCP>
Date: 15 May 89 17:45:59 GMT
References: <219@mlfarm.UUCP> <2170@Portia.Stanford.EDU>
Reply-To: rwright@novavax.UUCP (Ronald K. Wright)
Organization: Nova University, Fort Lauderdale, Florida
Lines: 22

In article <2170@Portia.Stanford.EDU> karish@forel.stanford.edu (Chuck Karish) writes:
>[ Note changed Newsgroups: and Followup-To: headers ]
>
>In article <219@mlfarm.UUCP> ron@mlfarm.UUCP (Ronald Florence) wrote:
>>In using the ancient (v.7 derived) uucico supplied with SCO Xenix
>>386ps, version 2.2.3, we have difficulties at 2400 baud when our
>>uucico starts up in SLAVE mode and has to switch in the middle of the
>>transmission to MASTER mode.  As far as I can determine, our system
>>does not respond correctly after the remote system sends the 'H'
...edited out remainder..

I have exactly the same problem from a Hayes on Tandy Xenix to a
Zenith with SCO Xenix 2.2.3.  Thus I believe this is a generic
problem.

I do not have, but would appreciate a generic fix.

-=-=-==-==-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
R.K. Wright 				| uflorida!novavax!rwright
Chief Medical Examiner			| uflorida!novavax!medexam!rkw
Assoc.Professor of Pathology(Univ.Miami)| umbio!rwright
Broward County Florida			| allegra!novavax!medexam!rkw