Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!HNYKUN11.BITNET!U211344
From: U211344@HNYKUN11.BITNET (Olaf 'Rhialto' Seibert)
Newsgroups: comp.sys.amiga.tech
Subject: RDF: default options in the MountList
Message-ID: <8905101602.AA15151@jade.berkeley.edu>
Date: 10 May 89 16:50:20 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Lines: 31

I got a few complaints from people who said that the defaults you
supply in the Mountlist entry for RDF: (was posted some time ago
on sources/binaries) did not work for them.

I recently (i.e. last night) found the reason for this.

The mountlist entry was suggested to look like

RDF:    Handler = l:RDF-Handler
        Device = trackdisk.device
        Unit = 0
        Flags = 0
#

This worked for me. That was because I was using the Arp 1.1 Mount
command which does what I expected. The 1.3 mount command does
NOT what I expected, but does not complain either. The 1.3 Arp
Mount command complains about this construction.

Solution: Change Handler into FileSystem, and everything starts
working as documented. (except that I somehow by accident must have
deleted the line that made DeleteFile() work). I might send a
maintenance release to Bob in case enough interest is expressed
(by mail, of course).

Freely_Distributable=Greetings(Not_For_Any_Commercial_Purpose)->
        Olaf.Seibert;

Astounding News! By Express Via Norfolk!
The Atlantic Crossed in Three Days!        Olaf 'Rhialto' Seibert
[E.A. Poe, 1844]                           U211344@hnykun11.bitnet