Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!rutgers!apple!well!rchrd
From: rchrd@well.UUCP (Richard Friedman)
Newsgroups: comp.sys.apollo
Subject: Enabling logins with sr10.1 and Hayes 2400bd modem...
Message-ID: <11602@well.UUCP>
Date: 9 May 89 21:25:52 GMT
Distribution: comp
Organization: RCHRD 2855 Telegraph #415 Berkeley CA 94705
Lines: 31

I have just upgraded a stand-alone DN3000 to SR10.1 and
was that fun!       Now I find that not only doesn't
Kermit (4E.070) not run (it has to be recompiled as if
for BSD4.2), but I cant get the getty process to handle
my Hayes 2400 bd modem.

Any suggestions on:
  1) what device type from /etc/gettytab should I specify in
     the /dev/tty01 entry in /etc/ttys for the Hayes 2400B
     smartmodem.
  2) what commands should I issue to the modem to set it up
     properly for logins.  (This is the modem without switches!
     It has to be set up by issuing AT commands ).

So far I have not been able to get the modem to stay online.
I hangs up the line as soon as I log in.  Also, is there anything
special about an account in the registry that permits it to 
log into the system?  None of this is clearly described in the
apollo documentation for 10.1

Any help will be greatly appreciated.   I've wasted too much time
on all this....!

Richard Friedman (Pacific-Sierra Research/Berkeley)
    rchrd @ well
    (415) 540 5216

-- 
 ...Richard Friedman [rchrd]  Berkeley, CA.                         
    rchrd@well.uucp        -or-
   {ucbvax,lll-lcc,pacbell,hplabs}!well!rchrd