Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!hplabs!hpfcdc!rjn
From: rjn@hpfcdc.HP.COM (Bob Niland)
Newsgroups: comp.sys.hp
Subject: Re: Starting SoftPC and MS DOS on HP-UX
Message-ID: <5570180@hpfcdc.HP.COM>
Date: 13 May 89 16:30:40 GMT
References: <1013@dinl.mmc.UUCP>
Organization: HP Ft. Collins, Co.
Lines: 26

re: "MS DOS is supported via the DOS Coprocessor card.  This is orderable as
     a separate product:"

..also SoftPC(R),  which is an alternative solution.

  98870A SoftPC software and documentation
  98870S SoftPC license


> S300 DOS coprocessor			HP 98286A
> S300 DOS coprocessor software		HP 98531A
> S300 DOS system (both of the above)	HP 98286S
> S300 DOS coprocessor + 1 Meg RAM	HP 98286T

These numbers are a little old.  The 98286A card is no longer sold separately.
It is part of the 98286S/T bundles and the  98286D diskless node kit.

> 360 KB 5 1/4 floppy			HP 9127A

The co-processor solution also supports 3.5" (270K..1.6M) floppies via the
9122C drive (and any other SS/80 3.5" drive you might have on hand).

Regards,                                              Hewlett-Packard
Bob Niland                                            3404 East Harmony Road
ARPA: rjn%hpfcrjn@hplabs.HP.COM                       Fort Collins
UUCP: [hplabs|hpu*!hpfcse]!hpfcla!rjn                 CO          80525-9599