Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!ulowell!cbmvax!eric From: eric@cbmvax.UUCP (Eric Cotton) Newsgroups: comp.sys.amiga Subject: Re: Preferences Key Repeat Delay Message-ID: <6957@cbmvax.UUCP> Date: 23 May 89 16:05:57 GMT References: Reply-To: eric@cbmvax.UUCP (Eric Cotton) Distribution: comp.sys.amiga Organization: Commodore Technology, West Chester, PA Lines: 29 In article lynn@rave.phx.mcd.mot.com (Lynn D. Newton) writes: >Here's a relatively dumb and naive question from a relatively >experienced Amigan -- couldn't find the answer by quick perusal, >so maybe someone just knows and can tell me and save me the >trouble of looking it up who-knows-where: > >I wanted to reset the Key Repeat Delay in Preferences a little >faster. I set it in Preferences, saved it, and found it didn't >change. The slider gadget will let me place the knob anywhere on >the line, and if I move it to the right it slows down. But if I >move to the left it always returns to where it was. Presumably I >have hit some globally-defined minimum. (The knob is right about >on the space between Key and Repeat.) I gather there are probably >only 4 or 8 or some other small number of values that the >parameter accepts and that the space between increments is larger >than, for instance, color definitions. If so, then does anyone >know why it won't show the knob all the way to the left if one >has hit the minimum? Or is there something wrong here? I was curious myself so I took a look at the source. It turns out that the minimum allowable value for the delay is 400000 microseconds. So even thought the Prefs prop gadget lets you go all the way to 0, on exit it'll bump the value up. Why the prop lets you go below 400000 micros to begin with is another mystery... -- Eric Cotton Commodore-Amiga (215) 431-9100 1200 Wilson Drive {uunet|pyramid|rutgers}!cbmvax!eric West Chester, PA 19380 "I don't find this stuff amusing anymore."