Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!cs.utexas.edu!swrinde!kent From: kent@swrinde.nde.swri.edu (Kent D. Polk) Newsgroups: comp.sys.amiga Subject: Re: DNet multiplexing ( was Re: uw ) Message-ID: <16937@swrinde.nde.swri.edu> Date: 31 May 89 19:00:28 GMT References: <50125@tut.cis.ohio-state.edu> <363@xdos.UUCP> <9993@watcgl.waterloo.edu> Reply-To: kent@swrinde.UUCP (Kent D. Polk) Organization: Southwest Research Institute, San Antonio, Texas Lines: 20 In article <9993@watcgl.waterloo.edu> bmacintyre@watcgl.waterloo.edu (Blair MacIntyre) writes: [..] > I don't use DNET anymore as just a terminal because ctrl-S and ctrl-Q > do not stop/start the data until a couple of screen after you press > them, in some cases. [...] >= Blair MacIntyre, bmacintyre@watcgl.{waterloo.edu, UWaterloo.ca} // = Try holding down the RIGHT Mousebutton. Sometimes it takes two hits, but always works for me - even at 9600 baud. (Ctrl-S/Ctrl-Q never work for me.) ======================================================= Kent Polk - Southwest Research Institute {cs.utexas.edu, gatech!petro sun!texsun}!swrinde!kent kent@swrinde.nde.swri.edu ------------------------------------------------------- "Anything worth doing is worth overdoing" =======================================================