Path: utzoo!attcan!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!UDEM.BITNET!CHIASSA From: CHIASSA@UDEM.BITNET (Alyre CHIASSON) Newsgroups: comp.sys.atari.st Subject: Hard Drive and PC-DITTO II Message-ID: Date: 26 May 89 14:07:45 GMT Sender: daemon@ucbvax.BERKELEY.EDU Organization: The Internet Lines: 26 I just bought a MegaFile 30 for my 1040ST and decided to try to get PC-DITTO II to recognize the hard drive. Everthing seems to come up fine until I do a DIR command on partion C: which gives me the error message "capacity overflow during division,"(DOS 3.2). I have no idea what this means or how to correct it. I am booting the system from floppy with only the PC-DITTO program in the autofolder and an autotime.prg to read the clock that I have in the cartridge port. I have the config.sys file set up as suggested in the manual and have reproduced it below. device=pc_dhd.sys buffers=16 device=driver.sys /D:0/T:80 device=driver.sys /D:1/T:40 (for my 5.25 drive) When the system comes up it does says 3 partitions which is correct I have my drive divided into 3 of 10 meg each. I also see the message that pc_dhd.sys has been installed. My drive was formatted with the program that came on the disk with my hard drive. From the PC-DITTO manual I understand that I do not have to reformat it under DOS. Can someone tell me what I am doing wrong or the source of the problem. Many thanks.