Path: utzoo!attcan!uunet!bywater!acheron!clarke
From: clarke@acheron.UUCP (Ed Clarke)
Newsgroups: comp.sys.ibm.pc.rt
Subject: Re: Pinouts for RT serial ports?
Message-ID: <598@acheron.UUCP>
Date: 19 May 89 23:22:29 GMT
References: <5552@cs.utexas.edu>
Lines: 29

From article <5552@cs.utexas.edu>, by bunda@cs.utexas.edu (John Bunda):
> I can't seem to find them, not even in the Hardware Reference.  Does
> anyone have the pinout definitions for the 10-pin serial ports?

Sure, look under 'RS-232C Adapter' in the third volume.  Just in case
you don't have that volume:

1   Transmit Data               6   Receive Data
2   Data Terminal Ready         7   Data Set Ready
3   Request to Send             8   Clear to Send
4   Ring Indicate               9   Data Carrier
5   No Connection              10   Signal Ground

Transmit Data, Data Terminal Ready and Request to Send are OUTPUT from
the card, all others are input ( except ground which is neither ).

+-------+
| 5  10 +-+
| 4   9   |
| 3   8   |    <----- View from rear of adapter showing polarization
| 2   7   |
| 1   6 +-+
+-------+

Good luck!

-- 
Ed Clarke
uunet!bywater!acheron!clarke