Path: utzoo!attcan!uunet!cs.utexas.edu!rutgers!apple!han
From: han@Apple.COM (Byron Han, wyl E. coyote )
Newsgroups: comp.sys.mac.programmer
Subject: Re: Patching a trap address
Message-ID: <31640@apple.Apple.COM>
Date: 25 May 89 16:59:21 GMT
References: <5563@hubcap.clemson.edu> <23164@dhw68k.cts.com>
Organization: Apple R&D - Networking & Communications
Lines: 19

In article <23164@dhw68k.cts.com> thecloud@dhw68k.cts.com (Ken McLeod) writes:
>
>  The general strategy for patching traps is to first call GetTrapAddress,
>which will give you the (current) address of the trap you're patching.
>You save this address off somewhere in your code, and then call SetTrapAddress

Actually NGetTrapAddress and NSetTrapAddress defined in IM-IV are the
recommended calls.
+-----------------------------------------------------------------------------+
| Disclaimer: Apple has no connection with my postings.                       |
+-----------------------------------------------------------------------------+ 
Byron Han, Communications Scapegoat   At Apple, we change the world everyday.
Apple Computer, Inc.                  -----------------------------------------
20525 Mariani Ave, MS27Y              Internet: han@apple.COM
Cupertino, CA 95014                   UUCP:{sun,voder,nsc,decwrl}!apple!han
------------------------------------  GENIE:BYRONHAN   CompuServe:72167,1664
ATTnet: 408-974-6450                  Applelink:HAN1   HAN1@applelink.apple.COM
-------------------------------------------------------------------------------