Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!trantow
From: trantow@csd4.milw.wisc.edu (Jerry J Trantow)
Newsgroups: comp.sys.amiga.tech
Subject: Re: TOOLTYPE woes
Summary: Where is the FIX???
Keywords: ToolTypes
Message-ID: <2884@csd4.milw.wisc.edu>
Date: 12 Jun 89 13:11:14 GMT
References: <11892@well.UUCP> <2680@csd4.milw.wisc.edu> <19333@cup.portal.com>
Sender: news@csd4.milw.wisc.edu
Reply-To: trantow@csd4.milw.wisc.edu (Jerry J Trantow)
Organization: University of Wisconsin-Milwaukee
Lines: 13

In article <19333@cup.portal.com> FelineGrace@cup.portal.com (Dana B Bourgeois) writes:
>Jerry, I read in one of the magazines (I think) that Info gets
>confused sometimes when it saves your TOOLTYPE changes to disk.
>It loses the ending NULL which causes the routines reading the
>TOOLTYPE to act funny.  That's why when you go back to Info and
>Dana

I have been bitten by this bug quite a few times.  Is there any 
way to correct this?  Will it be fixed in some intermediate release?

Along with fixing this problem, how about a way to tell WorkBench that 
a program has modified an Icon so we don't have to close and open the
window for changes to be acknowledged?