Path: utzoo!attcan!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!CC.MSSTATE.EDU!eddie
From: eddie@CC.MSSTATE.EDU (Eddie Mikell)
Newsgroups: comp.sys.apple
Subject: Apple II GS, appletalk, and imagewriter emulator
Message-ID: <8906091242.AA08964@Wally.CC.MsState.Edu>
Date: 9 Jun 89 12:42:19 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 21

Let me start off by apologizing if this is a duplicate posting, but I think
the last one vanished in a network black-hole.

I have been asked to assist in setting up a lab which is using an Apple II
GS which is connected by appletalk to a Laserwriter IInt.

While I am not a GS pro, I followed the instruction manual in trying to
make something print to the laserwriter.  I ran the system untilities, selected
chooser, and selected the laserwriter (which it detected over the net). It
then downloaded the imagewriter emulator into the laserwriter and the 
laserwriter printed the message "emulator successfully load".  So far so good.  

I quit the utilities, rebooted into appleworks, loaded a file and tried to
print to an imagewriter at slot 7.  Nothing.

I have tried this scenario several times, but have not be able to print.

Any suggestions?

Eddie H. Mikell
Mississippi State University