Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!tut.cis.ohio-state.edu!ucbvax!urz.unibas.ch!hofer
From: hofer@urz.unibas.ch ("Remo Hofer")
Newsgroups: comp.sys.atari.st
Subject: Rsconf in TOS 1.4
Message-ID: <374*hofer@urz.unibas.ch>
Date: 2 Jun 89 11:38:41 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 13

Some documentation about TOS 1.4 says:
Rsconf(-1,-1,-1,-1,-1,-1) does return the old values of USART registers.
(That was true for all TOS versions, but wasn't documented)
Rsconf(-2,-1,-1,-1,-1,-1) does return the old value for the baud rate.
(That is only true for TOS 1.4)
Does this mean that you can inquire all settings of the RS232 except
the setting of the handshake? I think, it would be nice, if we could inquire
the handshake settings. Any comments? Maybe somebody at Atari?

Remo Hofer
hofer@urz.unibas.ch

----------------------------------------------------------------------------