Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!rutgers!sun-barr!decwrl!shlump.dec.com!riscy.dec.com!dbb
From: dbb@riscy.dec.com (David Barrett)
Newsgroups: comp.sys.atari.st
Subject: Re: HD drivers?
Message-ID: <1257@riscy.dec.com>
Date: 6 Jun 89 17:17:31 GMT
References: <8906031231.AA14867@ucbvax.Berkeley.EDU>
Sender: news@riscy.dec.com
Organization: DEC NYC URC
Lines: 22


> Once again: is there a way to use TWO drives with one ADAPTEC (i.e.
> within an SCSI-unit) as devices 0 and 1 ??? Sure, I know that the
> ADAPTEC is able to control both, but where the hell is a driver that
> gives me the opportunity to address them both ? Anyone who knows ?
> Anyone who cares ?
> 
> 
> Klaus Hahn
> Marburg, West-Germany             bitnet: HAHN_K@DMRHRZ11

Yes, Klaus, this is definitely, and quite easily 'doable'.  I've got 2 65MB Maxtor drives
hooked up to an Adaptec controller, addressed as LUN 0 & 1 without any problems.
I'm using Supra's formatting utility and drivers, which automagically recognize both
drives.

----------------------------------
David Barrett		 		UUCP:	...!decwrl!riscy.dec.com!dbb
Digital Equipment Corporation
New York ULTRIX Resource Center		INET:	dbb@riscy.dec.com

These opinions are mine, all mine!!!  Digital may or may not wish to agree...