Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!tut.cis.ohio-state.edu!purdue!bu-cs!dartvax!eleazar.dartmouth.edu!anarch
From: anarch@eleazar.dartmouth.edu (Brendan Hahn)
Newsgroups: comp.sys.mac.programmer
Subject: Lightspeed Pascal & SE/30
Summary: What the hell is a 'bus error'?
Keywords: bus error SE/30
Message-ID: <13842@dartvax.Dartmouth.EDU>
Date: 7 Jun 89 23:50:06 GMT
Sender: news@dartvax.Dartmouth.EDU
Reply-To: anarch@eleazar.dartmouth.edu (Brendan Hahn)
Organization: Demon Software
Lines: 12


     Does anyone out there know what a 'bus error' in Lightspeed Pascal is?  I 
have just switched to an SE/30 and they have been popping up everywhere.  The
message is not documented in the manual and I haven't got the tech support
number.  I am at a loss and the problem is really disrupting my work.  It seems
to have something to do with pointer access; after the fourth or fifth time a
program uses a pointer it bombs.  The programs will work fine when moved to a
different computer however.  I'm using LSP 2.0p1 with a brand-new SE/30 and
system 6.0.3.  Any help would be greatly appreciated!

     P.S. If the grammar in this note leaves a little to be desired it's because
the comma key on this terminal doesn't work.