Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!rutgers!cs.utexas.edu!ut-emx!chcu321
From: chcu321@ut-emx.UUCP (Michael J. Liebman)
Newsgroups: comp.sys.mac.programmer
Subject: Code timing with LSC 3.02
Keywords: cpu time, LSC
Message-ID: <13895@ut-emx.UUCP>
Date: 9 Jun 89 14:28:15 GMT
Organization: UT-Austin, Department of Chemical Engineering
Lines: 24


I'm a novice C programmer using LSC 3.02 on my Mac SE/30 (aka SEx).
In the interest of comparison to the MicroVax I use at the office I
was going to run some benchmark tests.  Unfortunately, I haven't been
able to find a convenient way of accessing the CPU time.  I know
about the Profiler, but I'd like a way to have the information in
variables.  Is the best way to modify profiler.c?  I suppose I can do
it if I have to.


Thanks for any suggestions.

Mike

-- 
----------------------------------------------------------------------------

  Michael J. Liebman             INTERNET:
  Dept. of Chemical Engineering    mjl@cheme1.che.utexas.edu (128.83.162.2)
  University of Texas at Austin    chcu321@emx.cc.utexas.edu (128.83.1.33)
   (512) 471-5150.ma.bell        BITNET:
                                   liebman@UTAIVC

----------------------------------------------------------------------------