Path: utzoo!censor!geac!jtsv16!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!unmvax!deimos.cis.ksu.edu!uxc!uxc.cso.uiuc.edu!ux1.cso.uiuc.edu!osiris.cso.uiuc.edu!dpgerdes
From: dpgerdes@osiris.cso.uiuc.edu
Newsgroups: comp.unix.microport
Subject: 386 Boot problem
Message-ID: <42700018@osiris.cso.uiuc.edu>
Date: 9 Jun 89 21:22:00 GMT
Lines: 39
Nf-ID: #N:osiris.cso.uiuc.edu:42700018:000:1845
Nf-From: osiris.cso.uiuc.edu!dpgerdes    Jun  9 16:22:00 1989



    I am having a problem with the boot program on V/386 3.0e.1.  I am
not sure if it is a hardware or software problem tho.  I have a Compaq
386/25 model 300 with a combination hard/floppy ESDI controller.
Approximately 60% of the time I boot the machine, it gets as far as 
displaying the dots (............) and then hangs before displaying
the  boot:  prompt.  The machine at that point requires a cold boot.
The problem happens with equal frequency for both warm and cold boots.

My usual boot proceedure is to hit Ctrl-Alt-Del and wait for the dots.
Power down, power up, wait for the dots.
Repeat 1 to 10 times until the boot: prompt follows.

    The reason I think that it may be hardware is that I previously had
the exact same system running on a Dell 310 with no such problems (others
yes, but not that one.)  But why does it work sometimes and not others?

    I previously checked w/ uPort tech support and they verified that
I had a good copy of the boot file.
    I have jiggled the cables and boards. I do not think it is thermal
as it happens warm or cold (as opposed to the last Compaq I had which
would get disk failures until it had been turned on for at least 5 minutes.)

    BTW, I do make a good beta-tester.  If a program is going to break,
it will do it for me.  (Except my own of course ;-)

    Thanks,

    -dave gerdes

--------------------------------------------------------------------------------
UUCP:    {ihnp4,pur-ee,convex}!uiucdcs!uiucuxc!osiris!dpgerdes
INTERNET: dpgerdes@osiris.cso.uiuc.edu  CSNET:  dpgerdes%osiris@uiuc.csnet
MILNET:   dpgerdes@osiris.arpa          BITNET: dpgerdes@osiris
US Mail: USA CERL, PO Box 4005 or 2402 Newmark Drive, Champaign, Il 61820-1305
Voice/Phone: Commercial		(217) 352-6511 x591
--------------------------------------------------------------------------------