Path: utzoo!attcan!uunet!cs.utexas.edu!sun-barr!rutgers!tut.cis.ohio-state.edu!uccba!ucqais!rainwatr
From: rainwatr@ucqais.uc.edu (Donald J. Rainwater)
Newsgroups: comp.unix.ultrix
Subject: Ultrix standalone backup disk
Keywords: build 3.0 RL02 8650
Message-ID: <1696@ucqais.uc.edu>
Date: 8 Jun 89 17:40:39 GMT
Organization: Univ. of Cincinnati Computer Center
Lines: 17


	We've got Ultrix 3.0 installed on an 8650.  This was no small task,
since we installed 3.0 from a 2.x standalone backup RL02.  Basically, the
installation procedure ran to a point, then Ultrix support talked us thru
the rest of the procedure manually.

	What we would like to do is create a 3.0 standalone backup disk, so
we're set if we want to re-install or whatever.  Under VMS, there is a
procedure for building a standalone backup kit (SYS$UPDATE:STABACKIT.COM).
Is there something similar for Ultrix?  If not, is there any way I can
create a 3.0 standalone backup disk?

-- 
Don Rainwater, University of Cincinnati Computer Center
rainwatr@ucbeh.san.uc.edu
rainwatr@ucbeh.bitnet
rainwatr@ucqais.uc.edu