Path: utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!mcsun!unido!fauern!tumuc!lan!rommel
From: rommel@lan.informatik.tu-muenchen.dbp.de (Kai-Uwe Rommel)
Newsgroups: comp.os.os2
Subject: Re: uEMACS
Message-ID: <976@tuminfo1.lan.informatik.tu-muenchen.dbp.de>
Date: 20 Dec 89 13:32:42 GMT
References: <5345@udccvax1.acs.udel.EDU>
Sender: news@lan.informatik.tu-muenchen.dbp.de
Reply-To: rommel@lan.informatik.tu-muenchen.dbp.de (Kai-Uwe Rommel)
Organization: Inst. fuer Informatik, TU Muenchen, W. Germany
Lines: 24

In article <5345@udccvax1.acs.udel.EDU> lance@vax1.acs.udel.EDU (Daniel A Lentz) writes:
>1. When I use the version of uEMACS posted here recently, all works fine for
>about an hour, and then I get a protection violation, causing all of my work
>to be lost in never-never land. I'm using uEMACS under PM with ASAVE set.

(I compiled and posted uEMACS)

What was the exact situation, what were you doing at the moment of the
protection fault inside the editor ?

After posting it, I found one bug: When you point with the mouse pointer
into the command line of uEMACS and press the right mouse button, you
get a protection fault. I'm working on it and will repost the .EXE when
fixed (need time ...). 

Was it this bug ?

It is a 'golden rule' not to work over hours without saving !
uEMACS was ported from the Unix and DOS versions and may have bugs, but
I did not find other than the one described above until now.

Kai Uwe Rommel,
Munich
rommel@lan.informatik.tu-muenchen.dbp.de