Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!wuarchive!udel!mmdf
From: robin%sabre.uucp@cunyvm.cuny.edu
Newsgroups: comp.sys.amiga
Subject: Re: VLT won't save configuation
Message-ID: <6162@nigel.udel.EDU>
Date: 15 Dec 89 02:15:54 GMT
Sender: mmdf@udel.EDU
Lines: 23

In article <38265@lanl.gov> tjf@lanl.gov (Tom J Farish) writes:
>Hi...When I select "Save Configuration" in VLT, the disk spins
>and it seems OK, buth then when I run VLT at a later date, the
>previous config was not saved after all.  (I run from a floppy).
>How Come?

If you have an init file in the s: directory, it will override the saved
configuration.  Load it up, make your changes, save it, and then remove the
init files from s: and the current directories (copy them somewhere else, you
don't want to lose them).  Then make sure that the VLT.dat (I think thats its
name) is in your current dir: when you fire it up.

This stuff is documented in the docs that came with it...


+-----------------------------------------------------------------------------+
|The views expressed herein, are the sole responsibility of the typist at hand|
+-----------------------------------------------------------------------------+
|USNail:                               UUCP:                                  |
|2323 Wells Branch Pkwy., #G107        cs.utexas.edu!romp!ibmchs!auschs\      |
|Austin, TX  78728                     !sabre.austin.ibm.com!robin            |
|Home: (512)251-6889                          ^^^^^^^^^^^^^^<-MUST BE INCLUDED|
+-----------------------------------------------------------------------------+