Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!cs.utexas.edu!usc!zaphod.mps.ohio-state.edu!mips!apple!claris!peirce
From: peirce@claris.com (Michael Peirce)
Newsgroups: comp.sys.mac
Subject: Re: Using EtherTalk w/Laserwriter and/or Public Folder??
Message-ID: <10762@claris.com>
Date: 19 Dec 89 00:38:15 GMT
References: <10949@muvms3.bitnet>
Reply-To: peirce@claris.com (Michael Peirce)
Organization: Claris Corporation, Santa Clara CA
Lines: 26

In article <10949@muvms3.bitnet> mcguffey@muvms3.bitnet (Michael McGuffey) writes:
>
>We have a Mac II and a Mac IIci, each with an EtherTalk NB card.
>
>	2.  Does Public Folder support EtherTalk?  I've set both machine
>		to the EtherTalk in the Control Panel and rebooted, but
>		they can't seem to see one another.

Public Folder should run just fine over EtherTalk (or any type of xxxTalk). 

Are both machines in the same zone?  Did the Public Folder bootup icon come
up normal or with an X through it.  If normal, then Public Folder thinks 
things are OK.  If an X, then either Public Folder couldn't find the "Public"
folder, or AppleTalk (/EtherTalk) isn't turned on properly.  

If you have further problems with Public Folder drop me a line...

 Claris Corp. | Michael R. Peirce (author of Public Folder)
 -------------+--------------------------------------
              | 5201 Patrick Henry Drive MS-C4
              | Box 58168
              | Santa Clara, CA 95051-8168
              | (408) 987-7319
              | AppleLink: peirce1
              | Internet:  peirce@claris.com
              | uucp:      {ames,decwrl,apple,sun}!claris!peirce