Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!tut.cis.ohio-state.edu!ucsd!ucsdhub!hp-sdd!ncr-sd!ncrlnk!ncrwat!images!jrl
From: jrl@images.Waterloo.NCR.COM (john Latala)
Newsgroups: comp.terminals
Subject: Re: Vt102 Double-Height and other codes requested
Message-ID: <322@images.Waterloo.NCR.COM>
Date: 16 Dec 89 11:27:12 GMT
References: <6863@shlump.nac.dec.com>
Reply-To: jrl@images.Waterloo.NCR.COM (john Latala)
Distribution: na
Organization: NCR Canada Ltd, Waterloo, Ontario, Canada.
Lines: 21
Keywords:

In article <6863@shlump.nac.dec.com> sherwin@video.dec.com (JIM SHERWIN) writes:
...
>       NOTE:   To create the <ESC> char, w/in EDT, hold the
>               Control key down and strike the 3 key, twice.
>               Use the 3 on the main keyboard, not the numeric
>               key pad.
>
>               Also, these ESCAPE sequences are case sensitive.
...

A faster way to get a <ESC> while in EDT it to hit the ESC key twice. At
least this works on our VAX/VMS system under EDT. I don't remember
whether it works in the TPU EDT emulator or not.

You can also use the SPECINS command sequence under EDT. It's been a
while, I think the character sequence was in decimal wasn't it. If
that's true then doing <GOLD> '2' '7' SPECINS should do it. Check
SPECINS to make sure (I'm on UNIX right now, not the VMS system).

-- 
john.Latala@Waterloo.NCR.COM