Xref: utzoo sci.electronics:8991 comp.sys.ibm.pc:39766
Path: utzoo!attcan!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!sun-barr!lll-winken!uunet!garfield!chris2
From: chris2@garfield.MUN.EDU (Chris Paulse)
Newsgroups: sci.electronics,comp.sys.ibm.pc
Subject: AT-GPIB interface
Keywords: control with c/c++
Message-ID: <5305@garfield.MUN.EDU>
Date: 11 Dec 89 23:35:11 GMT
Organization: CS Dept., Memorial U. of Newfoundland, St. John's
Lines: 14


Anyone had any experience controlling the National Instruments
AT-GPIB board using C or C++?  The board arrived a couple of days
ago with the .OBJ drivers on a diskette.  The doc for BASIC is extensive,
but there's hardly any for C.  I plan to get some from the
manufacturer, but that'll take weeks (months).  I've libraried the
prescribed objects for the C language, but the MS linker won't
find the calls in the Library.  I'm using Zortech C/C++ which should
link cleanly with MS link 3.*, and the little doc on the C interface
says it's for use with MS cc.  Any help would be appreciated (even an
e-mail address for support from National Instruments)

Chris Paulse                   cpaulse@kean.ucs.mun.ca
Memorial Uni of Nfld           cpaulse@mun.bitnet