Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!accuvax.nwu.edu!nucsrl!telecom-request From: John Higdon Newsgroups: comp.dcom.telecom Subject: Re: Anyone Know of "Reserved" Suffix 0020 Message-ID: <2352@accuvax.nwu.edu> Date: 21 Dec 89 10:55:05 GMT Sender: news@accuvax.nwu.edu Reply-To: John Higdon Organization: TELECOM Digest Lines: 23 Approved: Telecom@eecs.nwu.edu X-Submissions-To: telecom@eecs.nwu.edu X-Administrivia-To: telecom-request@eecs.nwu.edu X-Telecom-Digest: Volume 9, Issue 587, message 6 of 9 Steve 'No Squash' Forrette writes: > I noticed a couple of years ago in PacBell land in Northern CA that > the 0020 suffix in just about any prefix always went to a loud, > continuous tone, which has about a 1/2 sec gap every 15 secs or so. > This also seems to be the case in Washington State. Anyone know what > this is used for? This tone is known in the biz as the "miliwatt". It is a 1004 hz tone that originates with a power of .001 watt in the CO. It is a standard so that by dialing that number, a field tech can readily measure the loss on that particular circuit. There was a number that a phone man used once on some PBX trunks that I had installed that produced the strangest sounds I had ever heard. They interacted with a big expensive-looking piece of hardware that he had. For the life of me, I can't remember that number. The test was supposed to be a very comprehensive analysis of the trunk. John Higdon | P. O. Box 7648 | +1 408 723 1395 john@bovine.ati.com | San Jose, CA 95150 | M o o !