Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!wuarchive!zaphod.mps.ohio-state.edu!samsung!shadooby!umich!itivax!sharkey!teemc!mibte!jbh
From: jbh@mibte.UUCP (James Harvey)
Newsgroups: comp.sys.amiga
Subject: Re: installing 2nd internal floppy
Message-ID: <2921@mibte.UUCP>
Date: 24 Dec 89 15:00:18 GMT
References: <495@auto-trol.UUCP> <1262@corpane.UUCP>
Organization: Michigan Bell Telephone Company
Lines: 31

In article <1262@corpane.UUCP>, sparks@corpane.UUCP (John Sparks) writes:
> In article <495@auto-trol.UUCP> todhor@auto-trol.COM () writes:
> >Well I'm just about through installing the Chinon 3.5 internal
> >...
> >appears fine except for this:  When I access either drive
> >say to do a read or dir BOTH lights on both drives come on.
> 
> Two things need to be done:
> 
> 1> set the drive select jumpers on the drives so that one is drive 0 and the
> other is drive 1.
> 
> -- 
> John Sparks   |  {rutgers|uunet}!ukma!corpane!sparks | D.I.S.K. 24hrs 1200bps
> |||||||||||||||          sparks@corpane.UUCP         | 502/968-5401 thru -5406 
I recently bought a Chinon drive to replace the original df0:
that came in my 2000.  I got it from an International BM clone
dealer and it didn't have any drive select jumpers!  Apparently
they assume the drive doesn't need these since IBM always selects
drive zero.  I had to do a fast shuffle with my other internal
drive to get things to work normally.

-- 

Jim Harvey                        |      "Ask not for whom the bell
Michigan Bell Telephone           |      tolls and you will only pay
29777 Telegraph                   |      Station-to-Station rates."
Southfield, Mich. 48034           | 

ulysses!gamma!mibte!jbh