Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!zaphod.mps.ohio-state.edu!usc!cs.utexas.edu!ut-emx!everett
From: everett@ut-emx.UUCP (Everett W)
Newsgroups: comp.sys.ibm.pc
Subject: help needed for ATI VGA wander
Keywords: ATI VGA wander Micronics 386
Message-ID: <22825@ut-emx.UUCP>
Date: 27 Dec 89 20:03:05 GMT
Distribution: usa
Organization: The University of Texas at Austin, Austin, Texas
Lines: 19

I purchased a 25Mhz Micronics 386 system with ATI vga wander recently. 
Unfortunately, ATI wander seems will not work with the motherboard.
The type of the motherboard is cache - I and has 32K sram cache. The monitor
I use is a NEC 3D. Each time I install the adoptor it works fine until it died
when it runs some programs. There is no responce from keyboard, reset. screen is
black. I can not repeat the crash with the same program. 
And it wouldn't reboot even I turn power off and on. If I take the adopter out
and reinstall it, it will run for a while and die. I tried the ega/relocated on
and off, with/out rambio.sys and it still not work.

  I would appreciated if somebody give me some advice on it. Is micronics has
compatability problem with ATI VGA wander ?

            Thanks for help.