Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!uwm.edu!uwvax!shorty.cs.wisc.edu!mark
From: mark@shorty.cs.wisc.edu (Mark Spankus)
Newsgroups: comp.sys.ibm.pc
Subject: Help needed for codepage selection!
Message-ID: <9482@spool.cs.wisc.edu>
Date: 4 Jan 90 03:11:18 GMT
Sender: news@spool.cs.wisc.edu
Organization: U of Wisconsin CS Dept
Lines: 19

Greetings!  (using this account by permission)

I'm looking for a way to load codepages 437, 850 & 865 on my Compaq 386 
(DOS 3.31) so that I may use the CHCP command to change codepages without 
having to change config.sys and autoexec.bat each time.
I am able to load codepage 437 & 850 OR codepage 865 & 850 at the same
time, but not all three at once.  I either get codepage 437 not prepared for
system, or codepage 865 not prepared for system.  Can it be done?? Any help
or suggestions would be greatly appreciated! Thanks in advance.

	-Trond Sjovoll 
 (OK to resond to this account.)


 -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
 Mark Spankus                       University of Wisconsin - Madison
 path: ...!{allegra,heurikon,ihnp4,seismo,ucbvax,uwm-evax}!uwvax!mark
 arpa:	mark@shorty.cs.wisc.edu
 -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-